Knowledge

Implementation of the ultra-low frequency sine vibration test

The minimum frequency for a sinusoidal vibration test is 0.1 Hz according to the test specification for electrical and electronic products. However, the minimum operating frequency in tests such as earthquake simulation, wave simulation and road transport simulation may be lower than 0.1Hz, so the implementation of ultra-low frequency sinusoidal vibration testing is a special problem in sinusoidal vibration testing and requires special discussion.

阅读更多 »
Knowledge

Precautions for the use of electrodynamic shaker

The electrodynamic shaker is an extremely widely used vibration test equipment in vibration testing, and its force ranges from hundreds of Newtons to thousands of Newtons. In practical applications, due to improper use, it often brings unexpected damage to the vibration table

阅读更多 »
Knowledge

Vibration Test Fixture Design

Usually, when a fixture is designed with only static loads in mind, a very severe major resonance occurs within the frequency range of the test. The clamping and bolting arrangement, while adequate statically, turns out to be very soft or compliant when analyzed dynamically. In other words, the mass of the test item and fixture is resonant on the soft springs consisting of the clamping arrangement to the shaker table. There are at least two major objections to this resonant condition.

阅读更多 »
Knowledge

Random vibration test requirements for vibration shakers

The requirements for random vibration testing are defined by the frequency-acceleration power spectral density (PSD for short) curve and its tolerance range. Therefore, in addition to meeting the basic requirements of a sinusoidal vibration shaker, a random vibration shaker has several specific technical specifications.

阅读更多 »
Knowledge

Shock Evironmental Effect

The large shock force generated by the impact comes from the change in momentum (mv) of the object in motion with the object being struck (e.g., hard ground) at the moment of very short contact (Δt),

阅读更多 »
Knowledge

Selection of special shakers

In environmental and reliability testing, there are some shaking tables used for comprehensive environmental testing, and the requirements for shaking tables are different according to the factors of comprehensive environment.

阅读更多 »
Knowledge

Functions and requirements of vibration test system horizontal table

Many products are subjected to vibration tests in three mutually perpendicular directions of x, y, and z. Small test pieces can be used to change the fixture installation state and use the fixture to flip to achieve three directions of vibration on the vertical vibration table. For large specimens, using the fixture flip method may cause excessive eccentric torque, and the vibration test of some special products (such as gyroscopes, etc.) requires that the installation state of the main shaft and the relative position of the earth remain unchanged, and it is not possible to change the fixture.

阅读更多 »

Ask For A Quick Quote

We will contact you within 1 working day, please pay attention to the email with the suffix “@labtone.cn”